Setup Diagram; Getting Started - Edimax Broadband Router User Manual

Setup Diagram

Figure 1.2 below shows a typical setup for a Local Area Network (LAN).

Getting started

This is a step-by-step instruction on how to start using the router and get connected to the Internet.
Setup your network as shown in the setup diagram above (fig 1.2).
You then need to set your LAN PC clients so that it can obtain an IP address automatically. All LAN clients require an IP
address. Just like an address, it allows LAN clients to find one another. (If you have already configured your PC to obtain
an IP automatically then proceed to step 3, page 11)
Configure your PC to obtain an IP address automatically
By default the broadband router's DHCP is on, this means that you can obtain an IP address automatically once you've
configured your PC to obtain an IP address automatically. This section will show you how to configure your PC's so that
it can obtain an IP address automatically for either Windows 95/98/Me, 2000 or NT operating systems. For other
operating systems (Macintosh, Sun, etc.), follow the manufacturer's instructions. The following is a step-by-step
illustration on how to configure your PC to obtain an IP address automatically for 2a) Windows 95/98/Me, 2b)
Windows XP, 2c) Windows 2000 and 2d) Windows NT.
2a) Windows 95/98/Me
1. Click the Start button and select Settings, then click Control Panel. The Control Panel window will appear.
2. Double-click Network icon. The Network window will appear.
3. Check your list of Network Components. If TCP/IP is not installed, click the Add button to install it. If TCP/IP is
installed, go to step 6.
4. In the Network Component Type dialog box, select Protocol and click Add button.
5. In the Select Network Protocol dialog box, select Microsoft and TCP/IP and then click the OK button to start
installing the TCP/IP protocol. You may need your Windows CD to complete the installation.
6. After installing TCP/IP, go back to the Network dialog box. Select TCP/IP from the list of Network Components and
then click the Properties button.
Check each of the tabs and verify the following settings:
Bindings: Check Client for Microsoft Networks and File and printer sharing for Microsoft Networks.
Gateway: All fields are blank.
DNS Configuration: Select Disable DNS.
WINS Configuration: Select Disable WINS Resolution.
IP Address: Select Obtain IP address automatically.
Figure 1.2
5