Tuner Operation; Auto Memory Entry; Direct Access Tuning; Frequency Step Setting - Kenwood DPX-MP3110 Instruction Manual

Tuner Operation

Auto Memory Entry

Putting stations with good reception in the memory
automatically.
1
Select the band for Auto Memory Entry
Push the Control knob towards up or down.
2
Enter Menu mode
Press the [M.JOG] button for at least 1 second.
"Menu" is displayed.
3
Select the Auto Memory Entry mode
Push the Control knob towards up or down.
Select the "A-Memory" display.
4
Open Auto Memory Entry
Press the Control knob for at least 1 second.
When 6 stations that can be received are put in the
memory, Auto Memory Entry closes.
Function of remote control

Direct Access Tuning

Entering the frequency and tuning.
1
Enter Direct Access Tuning mode
Press the [DIRECT] button on the remote
control.
"– – – –" is displayed.
2
Enter the frequency
Press the number buttons on the remote
control.
Example:
Desired frequency
92.1 MHz (FM)
810 kHz (AM)
Cancelling Direct Access Tuning
Press the [DIRECT] button on the remote
control.
⁄
• You can enter the FM band frequency in steps of a
minimum of 0.1 MHz.
• If you make no button operation for 10 seconds, this
function is automatically canceled.
Press button
[0], [9], [2], [1]
[0], [8], [1], [0]

Frequency Step Setting

Changing the tuning frequency step.
The original setting is FM band 50 kHz, and AM
band 9 kHz.
1
Turn the power OFF
Press the [SRC] button for at least 1 second.
2
Switch the frequency step
While pressing the [1] and [5] buttons, press the
[SRC] button.
Release your fingers from the button after the
display appears.
The frequency step changes to FM band 200 kHz,
and AM band 10 kHz.
⁄
• When the same operation is repeated, the frequency
step returns to the original setting.
• When the frequency step is changed, the frequencies in
the memory are deleted.
11
|
English