Connecting Wires to Terminals
Steering remote control (Light Blue/Yellow)
REMO.CONT
To use the steering wheel remote control feature, you need to an exclusive
remote adapter (not supplied) matches your car is required.
When this terminal is not in use, leave its cap on.
Fuse (10A)
Wiring harness
(Accessory1)
Power control/Motor antenna control wire
(Blue/White)
TEL mute wire (Brown)
Motor antenna control wire (Blue)
Dimmer control wire (Orange / White)
White/Black
White
Gray/Black
Gray
Green/Black
Green
Purple/Black
Purple
Ignition wire (Red)
Battery wire (Yellow)
Ground wire (Black) - (To car chassis)
FM/AM antenna input
Front preout
Rear/SubWoofer preout
To Kenwood disc changer/
External optional accessory
If no connections are made, do not let the wire come out from the tab.
P.CONT
MUTE
ANT.
CONT
ILLUMI
To front left speaker
To front right speaker
To rear left speaker
To rear right speaker
Connect either to the power control terminal when using
the optional power amplifier, or to the antenna control
terminal in the vehicle.
Connect to the terminal that is grounded when either the
telephone rings or during conversation.
⁄
To connect the Kenwood navigation system, consult
your navigation manual.
Depending on what antenna you are using, connect either
to the control terminal of the motor antenna, or to the
power terminal for the booster amplifier of the film-type
antenna.
To car light control switch
Ignition key switch
Car fuse box
ACC
Car fuse box
(Main fuse)
–
+
Battery
21
|
English