Audio Control; Audio Setup; Speaker Setting; Sound Enhancer Select - Kenwood DPX-MP3110 Instruction Manual

General Operation

Audio Setup

You can set Sound system, such as follows;
Adjustment Item Display
Front High Pass Filter "HPF"
Rear High Pass Filter "HPR"
Low Pass Filter "LPF"
Subwoofer Phase "PHAS"
Volume offset "V-Off"
Loudness "LOUD"
Dual Zone System "2ZON"
⁄
• Volume offset: Sets each source's volume as a difference
from the basic volume.
• Loudness: Compensates for low and high tones during
low volume. (Only the low tone is compensated for
when the tuner is selected as a source.)
• Dual Zone System
Main source and sub source (Auxiliary input) output
Front channel and Rear channel separately.
- Set up the channel of sub source by "Zone2" of <Menu
System> (page 14).
- Select Main source by [SRC] button.
- Adjust the volume of Front channel by Control knob.
- Adjust the volume of Rear channel by <Audio Control>
(page 7).
- The Audio Control has no effect on sub source.
1
Select the source to adjust
Press the [SRC] button.
2
Enter Audio Setup mode
Press the Control knob for at least 1 second.
3
Select the Audio Setup item to adjust
Press the Control knob.
4
Adjust the Audio setup item
Turn the Control knob.
5
Exit Audio Setup mode
Press the Control knob for at least 1 second.
8
|
DPX-MP5110U/DPX-MP4110/DPX-MP3110
Range
Through/40/60/80/100/120/
150/180/220 Hz
Through/40/60/80/100/120/
150/180/220 Hz
50/60/80/100/120/Through Hz
Reverse (180°)/ Normal (0°)
–8 — ±0 (AUX: -8— +8)
Off/On
Off/On

Speaker Setting

Fine-tuning so that the System Q value is optimal
when setting the speaker type as follows;
Speaker type
OFF
For 5 & 4 in. speaker
For 6 & 6x9 in. speaker
For the OEM speaker
1
Enter Standby
Press the [SRC] button.
Select the "STANDBY" display.
2
Enter Speaker Setting mode
Press the Control knob.
"SP SEL" is displayed.
3
Select the Speaker type
Turn the Control knob.
4
Exit Speaker Setting mode
Press the Control knob.

Sound Enhancer Select

You can play back adding gorgeous heavy bass to
the sound.
1
Enter the Sound Effect mode
Press the [SE] button.
"SE SEL" is displayed.
2
Select the Sound effect item
Turn the Control knob.
Sound effect
Returns to the normal sound without Sound effect.
Moves the sound image up a notch and adjusts bass
Moves the sound image up two notches and adjusts
bass.
Changes to the value set in <Sound Enhancer
Control>(page 9).
When the Sound effect is ON, the "SE" indicator is
ON.
3
Exit the Sound Effect mode
Press the [SE] button.
Display
"SP Off"
"SP 5/4"
"SP 6*9/6"
"SP OEM"
Display
"SE Off"
"SE Low"
"SE High"
"SE User"