Chapter 5
Step D. Install the Adapter
In this step, you will:
Turn off the HP Netserver and remove the necessary covers or open the
panels
Install the adapter
Turn Off the HP Netserver and Open It
CAUTION
HP NetRAID-1M and 2M Accessory boards are not hot
pluggable. Unplug HP Netserver power cord(s) before
installing a HP NetRAID-1M or 2M board.
NOTE
Before you begin, you may need to look up information about
your HP Netserver in Information Assistant on the
HP Netserver Online Documentation CD-ROM. You will need
to know how to open or remove the HP Netserver panels and
covers, as well as any special instructions for installing a
board in a PCI slot of the HP Netserver.
Turn off the HP Netserver and open it, as follows:
1. Bring down the operating system properly, as described in your
NOS documentation.
2. Turn off the HP Netserver power and disconnect the power cord(s) and all
telephone cords.
42
Installation and Configuration