Hp Netraid Config - HP P3410A - NetRAID 1M RAID Controller Installation And Configuration Manual

Chapter 10
NOTE
SCSI ID 5 is reserved for the SAF-TE processor that manages
the hot-swap mass storage cage.
a SAF-TE processor. The number of the reserved SCSI ID
varies with the type of external enclosure.
For complete instructions on using HP NetRAID Assistant, see the HP NetRAID
Series User Guide.

HP NetRAID Config

HP NetRAID Config performs the same functions as HP NetRAID Assistant, but
it runs under Novell NetWare, SCO UnixWare, and SCO OpenServer.
HP NetRAID Config allows you to reconfigure and manage your RAID system
and monitor its status.
You do not need to reboot your HP Netserver to use HP NetRAID Config.
The command you use to start HP NetRAID Config utility depends on which
NOS you are using.
For Novell NetWare, type load megamgr
For SCO UNIX, type megamgr
For SCO UnixWare, type megamgr
For SCO OpenServer, type megamgr
124
Understanding HP NetRAID Utilities
For internal mass storage in some HP Netservers,
For external mass storage, a SCSI ID may be reserved for
The SAF-TE processor is displayed as PROC.