Without Seat Back Installation - DJG enRoute Instruction Manual

4358-4294 enRoute 5/18/07 7:44 AM
Belt-Positioning Booster:

Without Seat Back Installation

1
2
1
2
3
18
Page 21
To remove backrest from
seat base, backrest needs
to be in the most upright
position. Press down
firmly on backrest release
tab and rotate seat back
until it lays flat.
Lift backrest hook out of
the opening in seat base.
Store backrest for future
use.
Lay flap over hole where
backrest connects to the
base.
Place child restraint against
the back of the vehicle
seat. Place the child's
bottom and back flat
against the child restraint.
Place lap belt across
4
child's thighs. Lock buckle.
The belt should cross the
base of the child's neck
and across the chest (not
the face or neck). Pull up
on the shoulder belt to
tighten.
NOTE:
lap and shoulder belt are
placed under armrest as
shown.
Check periodically to ensure your child has not moved
out of position and loosened the shoulder belt.
WARNING
!
Do not use this child restraint
if the midpoint of your child's
head is above the top of the
vehicle seat back or vehicle
headrest.
Use only the vehicle's lap and
shoulder belt system when restraining the
child in this booster seat.
Check vehicle instructions
for more information about
air bag/child restraint use.
Do Not Use only the lap
belt when using this seat.
The shoulder belt must
always be adjusted snugly
across the child's chest.
NEVER place the shoulder
belt under the child's arms.
Failure to follow these warnings could
cause serious injury or death to your child.
19
Make sure the