Connection And Settings Of Network Cable; Connection Of Network Cable; Network Settings; Specifying An E-Mail Address For This Machine - Konica Minolta bizhub 223 User Manual

4.1 To begin operation
4.1.2

Connection and settings of network cable

To use the function of this machine that sends image data over the network, such as the Network Scan and
Network Fax functions, connection and settings of the network cable are required.

Connection of network cable

Connect a UTP cable (category 5 or later recommended) connected to the network to the Ethernet connector
on the machine.

Network settings

An IP address must be assigned to the machine and settings, such as the SMTP server, must be specified in
order to use the machine on the network. For the detailed procedure, refer to the [User's Guide Network Ad-
ministrator].

Specifying an E-mail address for this machine

An E-mail address must be registered to this machine to send scanned data via E-mail or to use the Internet
Fax function. This E-mail address is used for sending/receiving data. It is recommended that the E-mail ad-
dress registered for the administrator be used.
If the E-mail address registered for the administrator is not specified, the sender's E-mail address must be
entered for each Scan to E-mail operation. Note that Scan to E-mail operations are not possible if a From
address is not entered.
Reference
- If User Authentication is enabled, the E-mail address specified for each user will be From address.
bizhub 423/363/283/223
4
4-3