Xerox 3450B - Phaser B/W Laser Printer Service Manual page 103

3.
Using the included screwdriver, remove the 4 screws securing the Fuser to the
printer chassis.
4.
Pull back on both ends of the Fuser to remove it.
Note
The Fuser (1) is secured using two different size screws. When reinstalling,
the long screws go on the top and the short screws go on the bottom.
Reassembly
Caution
When reinstalling the Fuser, insert it gently and be careful not to force the
gears. Make sure that the Fuser is firmly seated on both ends and that the
ground wire (lower LEFT end) is not trapped under Fuser. The long screws
go on top and the short screws go on the bottom. Failure to reconnect the
ground wire can result in a premature printer failure. If the Fuser is not fully
seated, the fins on the inside of the rear cover will hit the Fuser when the
cover is closed.
8-6 Phaser 3450 Laser Printer Service Manual
1
s3450-043