Fuser Removal Pl 9.3.40) - Xerox 3450B - Phaser B/W Laser Printer Service Manual

4.
Lift the lever on the Bearing Clip at each end of the Transfer Roller.
Caution
The gear on the end of the Transfer Roller shaft is not secured in place. Hold
the gear when removing the roller to prevent it from falling into the printer.
Note
The 2 bearing clips are not interchangeable. The clip with the ground contact
goes on the gear side of the Transfer Roller.
5.
Slide the roller slightly to the right so the end of the shaft clears the lip on the
printer case and lift the Transfer Roller, together with the Bearing Clips and the
Transfer Roller Gear, out of the printer.

Fuser Removal PL 9.3.40)

Warning
The Fuser may be hot. Turn off power and allow at least 5 minutes for the
Fuser to cool before removal.
1.
Power down the printer and remove the power cord from the wall outlet.
2.
Remove the rear cover (page 8-14).
Service Parts Disassembly
Transfer Roller
1.
Bearing Clip
2.
1
2
s3450-002
8-5