Brother MFC-P2000 - B/W Laser Printer Service Manual page 57

Halogen heater lamp
(Blue 100V, Red 200V)
Heat Roller Bearing
Heat Roller Washer
Retaining ring
Heat roller gear
Taptite, pan M3x10
Connector plate
Note:


When reassembling the heat roller bearings, ensure that the direction of the bearing is
correct referring to Fig. 3-22.


The heat roller itself is very similar to the one for HL-1060/1070 printers. The heat
roller for the MFC-P2000 / HL-P2000 printer can be distinguished by the groove on
the edge of the roller. (Refer to Fig. 3-22.)


When replacing the heat roller cleaner with a new one, attach the cleaner referring to
the figure below;


Follow the instructions below when installing the
i) Place the cleaner felt of the cleaner ASSY for the thermistor under the heat roller.
ii) Place the end of the thermistor on the heat roller.
iii) Insert boss1 of the thermistor into the hole of the fixing unit frame.
iv) Do no place the thermistor on boss2 of the fixing unit frame.
Groove
Idle gear 16
-1 mm ~ +1 mm
Boss2
Boss1
Cleaner ASSY for thermistor
Heat roller
Taptite, pan
M3x10
Fixing unit frame
Fig. 3-22
Fig. 3-23
thermistor
Thermistor
Heat Roller
Fixing unit frame
Fig. 3-24
III-16
Heat Roller Bearing
4 mm ~ 5 mm
in the fixing unit.