Fixing Unit - Brother MFC-P2000 - B/W Laser Printer Service Manual

Note:
When reassembling the MP rear sheet feeder, remove the old grease and apply a
suitable amount of
ground leaf spring. (Refer to the figure below.)
3.8

Fixing Unit

(1) Remove the two M4x16 tapping screws.
(2) Lifting the
the two heater harness connectors.
Taptite, cup M4x16
Thermistor connector
Note:
The eject sensor actuator may also be removed when removing the fixing unit. In this
case be sure to re-assemble the eject sensor actuator when re-assembling the fixing unit.
grease (2 rice-grain size) between the heat sink of the motor and the
Ground leaf spring
Grease: FLOIL GE-676
(or FLOIL GE-334C)
Fig. 3-19
fixing unit, disconnect the thermistor connector on the
Fixing Unit
Heater harness
(Blue)
Fig. 3-20
III-14
Motor heat sink
6.2 mm
EL PCB
Thermistor harness
Heater harness (Brown)
EL PCB first, then
Taptite, cup M4x16