HP A7533A - Brocade 4Gb SAN Switch Base Release Note page 54

Hp storageworks fabric os 6.3.0c release notes (5697-0301, january 2010)
Hide thumbs Also See for A7533A - Brocade 4Gb SAN Switch Base:
Table of Contents

Advertisement

WebTools shows no SFP details for CEE interfaces.
On Enabling LLDP status and assigning FCoE priority bits globally, is
not getting reflected in Port Admin window.
Confusing error message when copying a source configuration from
a remote server.
Defect ID: DEFECT000247893 Summary: Port Auto Disable - Ports
outside of given range are being enabled.
IPv6 Address dropped from ag --show.
Port statistics details are not getting refreshed for EX ports.
WebTools Switch Admin: QoS: User defined priority group 0-7 does
not show up in the drop down for priority group id.
8/8 or 8/16 returned invalid value for swFCPortFlag MIB object
from 8/8 or 8/16 on SNMP manager.
MAC learning/flushing times are very slow on 2408 FCoE CN Switch
Switch.
Switch crashed on sending LOGO from Finisar LT.
Virtual Fabrics 6.2.0c when XISL use is enabled base logical switch
in switchshow shows Allow XISL Use as "off" open RFE 1249.
Modify fipcfg --advintvl cli to reject non-zero values for FKA
interval.
CUP needs to send an RSCN after coming back online after a cold
boot.
WT: FCoE connected devices tab, sort order of Device WWN is incor-
rect.
54
Fixed in Fabric OS 6.3.0
Workaround prior to code change:
Use the CLI interface.
Fixed in Fabric OS 6.3.0
Fixed in Fabric OS 6.3.0
Workaround prior to code change:
Do clean-up before downloading a
new CEE configuration: 1. In cmsh,
run "write erase" to clear
startup-config. 2. Reboot switch by
running "reboot" on FOS prompt. 3.
In cmsh, use "copy" command to
copy backup configuration into
running-config.
Fixed in Fabric OS 6.3.0
Workaround prior to code change:
Enable and disable port auto disable
for ports one at a time.
Fixed in Fabric OS 6.3.0
Workaround prior to code change:
Issue switchdisable and
switchenable, which causes the
IPv6 Address again to be presented.
Fixed in Fabric OS 6.3.0
Fixed in Fabric OS 6.3.0
Workaround prior to code change:
Use CLI to map user defined priority
group to a CoS.
Fixed in Fabric OS 6.3.0
Fixed in Fabric OS 6.3.0
Fixed in Fabric OS 6.3.0
Fixed in Fabric OS 6.3.0
Fixed in Fabric OS 6.3.0
Fixed in Fabric OS 6.3.0
Fixed in Fabric OS 6.3.0

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ae370a - brocade 4gb san switch 4/12

Table of Contents