HP A7533A - Brocade 4Gb SAN Switch Base Release Note page 17

DC SAN Backbone and DC04 SAN Director blade support
Fabric OS 6.3.0c is fully qualified and supports the DC Director blades listed in
Table 3 DC Director blade support matrix
Director blade
FC8-16
FC8-32
FC8-48
FC10-6
FC4-16IP (iSCSI blade)
FR4-18i (FCIP/FC Router blade)
FS8-18 (DC Switch Encryption FC blade)
FX8-24 (DC SAN Director Multiprotocol Extension
Blade)
FCOE10-24 (DC SAN Director Switch 10/24
FCoE Blade)
Power supply requirements for Director blades
Table 4 lists power supply requirements for Director blades to provide full redundancy (220 VAC
power is assumed).
Number of blades
Supported with Fabric OS 6.0.0b or later with any mix,
with up to eight blades of each type on the DC SAN
Backbone Director. There are no intermix restrictions. The
DC04 SAN Director requires Fabric OS 6.2.0a or later,
and supports up to four blades.
Not supported with the DC SAN Backbone Director or
DC04 SAN Director
Supported with Fabric OS 6.0.0b or later, with a maximum
of four blades of this type on the DC SAN Backbone
Director. Up to eight FR4-18i blades can be installed if
they are used only for FC FastWrite or FCIP without routing
on the DC SAN Backbone Director. The DC04 SAN
Director requires Fabric OS 6.2.0a or later, and supports
up to four blades.
Supported with Fabric OS 6.2.0b or later, with a maximum
of four blades of this type on the DC SAN Backbone Dir-
ector or DC04 SAN Director
Supported with Fabric OS 6.3.0x, with a maximum of two
blades per director. The DC SAN Director Switch 10/24
FCoE Blade can be installed in the same chassis only with
FC8-xx and/or FC10-6 blades. It is not supported in the
chassis with any other blades.
HP StorageWorks Fabric OS 6.3.0c Release Notes
Table 3.
17