HP A7533A - Brocade 4Gb SAN Switch Base Release Note page 37

will take effect. The persistent configuration is on a port-by-port basis; that is, if an 8-Gb device
is connected to a 2-Gb or 4-Gb SFP, and that SFP is replaced with an 8-Gb SFP, then the current
behavior of the mode is activated.
Updated command message when you execute the following lscfg --create command:
switch_128:FID128:admin> lscfg --create 1 About to create switch with
fid=1. Please wait... Logical Switch with FID (1) has been successfully
created.
You should expect to see the following revised message:
Logical Switch has been created with default configurations. Please
configure the Logical Switch with appropriate switch and protocol set-
tings before activating the Logical Switch.
Miscellaneous
After changing domain offset followed by issuing an hafailover command on a DC SAN Backbone
Director, DC04 SAN Director, or 4/256 SAN Director running Fabric OS 6.3 in interopmode 2, the
console log may generate continuous Unknown LSR type messages. You must either reboot the
switch or issue another hafailover command to terminate the messages.
During non-disruptive firmware upgrades, E_Ports in R-RDY mode may cause some frame drops on
the E-Port links.
WebTools functionality moved to DCFM
The functionality that was moved from WebTools 6.1.1 to DCFM applies to all versions of DCFM and
also applies to 6.3.x.
Table 8 WebTools functionality in DCFM
Function
Add unzoned devices
Analyze zone config
Table 8 describes these changes.
WebTools 6.1.0
Zone Admin
Zone Admin
HP StorageWorks Fabric OS 6.3.0c Release Notes
DCFM
Configure > Zoning
Reverse Find in the zoning dialog
provides the view of the zoned
and unzoned devices in the fabric
if all zone members are selected
for Find.
Configure > Zoning:
Reverse Find in the zoning dialog
provides the view of the zoned
and unzoned devices in the fabric
if all zone members are selected
for Find.
Device Tree and Topology:
Connected End Devices: Custom
display from the top level in the
main frame provides the device
tree and topology view for all the
zoned devices if all zones are
selected in the active zone
configuration.
Comments
37