Vlan Lag Settings - Dell PowerConnect 6224 User Manual

NOTE: If an Access port is chosen, the packet types that are accepted on the port (packet type) cannot be
designated. It is also not possible to enable or disable ingress filtering on an access port.
3. Use the Unit drop-down menu to view the VLAN Port Table for other units in the stack, if they exist.
Modifying Settings for Multiple Ports
1. Open the VLAN Port Settings page.
2. Click Show All.
The VLAN Port Table displays.
3. Click Edit for each Port to modify.
4. Edit fields as needed.
5. Click Apply Changes.
The VLAN port settings are modified, and the device is updated.
Configuring VLAN Ports Using CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide
• VLAN Commands
The following table summarizes the equivalent CLI commands for this feature.
Table 7-28. VLAN Port Configuration Commands
CLI Command
switchport access vlan
switchport general acceptable-frame-type
tagged-only
switchport general ingress-filtering disable Disables port ingress filtering.
switchport general pvid
switchport mode

VLAN LAG Settings

Use the VLAN LAG Settings page to map a LAG to a VLAN. Untagged packets entering the switch are
tagged with the LAGs ID specified by the PVID.
To display the VLAN LAG Settings page, click Switching → VLAN → LAG Settings in the tree view.
368
Configuring Switching Information
:
Description
Configures the VLAN ID when the interface is in access mode.
Discards untagged frames at ingress.
Configures the PVID when the interface is in general mode.
Configures the VLAN membership mode of a port.