Table of Contents
Advertisement
•
Ingress Filtering — Enables or disables Ingress filtering by the LAG. Ingress filtering discards packets
that are destined to VLANs of which the specific port is not a member.
•
Current Reserve VLAN — The VLAN currently designated as the reserved VLAN.
•
Reserve VLAN for Internal Use — The VLAN that is designated as the reserved VLAN after the device
is reset.
Assigning VLAN LAG Settings:
1 Open the VLAN LAG Setting page.
2 Select a LAG from the LAG drop-down menu and complete the fields on the page.
3 Click Apply Changes.
The VLAN LAG parameters are defined, and the device is updated.
Displaying the VLAN LAG Table
1 Open the VLAN LAG Setting page.
2 Click Show All.
The VLAN LAG Table opens.
Assigning LAGs to VLAN Groups Using CLI Commands
The following table summarizes the equivalent CLI commands for assigning LAGs to VLAN groups as
displayed in the VLAN LAG Setting page.
Table 7-29. LAG VLAN Assignments CLI Commands
CLI Command
switchport mode {access | trunk
| general}
switchport trunk native vlan
vlan-id
switchport general pvid vlan-id Configure the Port VLAN ID (PVID) when the
switchport general allowed vlan
add vlan-list [tagged |
untagged]
switchport general acceptable-
frame-type tagged-only
switchport general ingress-
filtering disable
Description
Configures a port VLAN membership mode.
Defines the port as a member of the specified
VLAN, and the VLAN ID as the port default
VLAN ID (PVID).
interface is in general mode.
Adds or removes VLANs from a general port.
Discards untagged packets at ingress.
Disables port ingress filtering.
Configuring Device Information
307
Advertisement
Table of Contents
