Dell PowerConnect 6224 User Manual page 557

Figure 9-25. IP Helper Interface Configuration
The IP Helper Interface Configuration page contains the following fields:
• Source IP Interface — Select the interface to use for UDP/Helper relays. Select All to configure relay
entries on all available interfaces.
• UDP Destination Port — Identifies destination UDP port number of UDP packets to be relayed. For a
list of UDP Port allocations, see Table 9-21.
• Server Address — The IPv4 address of the server to which packets are relayed for the specific UDP
Destination Port.
• IsDiscard — If True, packets arriving on the given interface with the given destination UDP port are
discarded rather than relayed. Discard entries are used to override global IP helper address entries
which otherwise might apply to a packet.
• Hit Count — The number of times a packet has been forwarded or discarded according to this entry.
• Remove — Select this option and click Apply Changes to remove the relay from the selected source IP
interface.
Adding an IP Helper Entry to an Interface
1. Open the IP Helper Interface Configuration page
2. Click Add to display the Interface Configuration Add page:
.
Configuring Routing
557