Stp Lag Settings - Dell PowerConnect 6224 User Manual

Displaying the STP Port Table and Configuring STP Port Settings
1. Open the STP Port Settings page.
2. Click Show All.
The STP Port Table displays.
Figure 7-40. STP Port Table
3. Use the Unit drop-down menu to view the STP Port Table for other units in the stack, if they exist.
4. To change the STP settings for one or more ports, select the Edit option for the port(s), configure the
desired settings, and then click Apply Changes.
Configuring Spanning Tree Port Settings Using CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide
• Spanning Tree Commands
The following table summarizes the equivalent CLI commands for this feature.
Table 7-22. Spanning Tree Port Commands
CLI Command
spanning-tree cost
spanning-tree disable
spanning-tree guard
spanning-tree auto-portfast
spanning-tree portfast
spanning-tree port-priority
spanning-tree tcnguard

STP LAG Settings

Use the STP LAG Settings page to assign STP aggregating ports parameters.
348
Configuring Switching Information
:
Description
Configures the spanning-tree path cost for a port.
Disables spanningtree on a specific port.
Selects whether loop guard or root guard is enabled on an interface.
Sets the port to auto portfast mode.
Enables spanning-tree portfast mode
Configures port priority.
Prevent a port from propagating topology change notifications.