4.
Disconnect the data cable (1) and power cable (2) from the rear of the drive.
Figure 7-23
5.
Remove the two retainer screws that secure the drive to the bay (1) then slide the drive forward
and out of the bay (2).
Figure 7-24
NOTE:
To install an external 3.5-inch drive, refer to
Bay on page
58
Chapter 7 Removal and Replacement Procedures Microtower (MT) Chassis
Disconnecting the Diskette Drive Cables
Removing a 3.5-inch Device (Diskette Drive Shown)
59.
Installing a Drive into the 3.5-inch External Drive