6.
Rotate the drive cage all the way up.
Figure 8-11
7.
Align the guide screw on the drive with the slot on the chassis. Slide the optical drive into the drive
bay until the two screw holes on the right side of the drive line up with the two screw holes on the
right side of the drive cage (1).
8.
Secure the optical drive by fastening two retainer screws through the holes in the right side of the
drive cage into the corresponding holes in the right side of the optical drive (2).
NOTE:
The M3 metric retainer screws for optical drives are black.
Figure 8-12
94
Chapter 8 Removal and Replacement Procedures Small Form Factor (SFF) Chassis
Rotating the Drive Cage Up
Extra retainer screws are provided on the front of the chassis under the hard drive cage.
Installing the Optical Drive