HP dx2810 - Microtower PC Service & Reference Manual page 58
Service reference guide: hp compaq dx2810 and dx2818 business pc and dx2810 small form factor business pc
Hide thumbs
Also See for dx2810 - Microtower PC:
- Hardware reference manual (57 pages) ,
- Quickspecs (39 pages) ,
- Product end-of-life disassembly instructions (8 pages)
Table of Contents
Advertisement
CAUTION:
slot cover for proper cooling of internal components during operation.
8.
To install a new expansion card, hold the card just above the expansion socket on the system
board then move the card toward the rear of the chassis so that the bottom of the bracket on the
card slides into the small slot on the chassis. Press the card straight down into the expansion socket
on the system board.
Figure 7-14
NOTE:
seats properly in the expansion card slot.
9.
Replace the slot cover lock and secure it in place with the screw that was previously removed.
Figure 7-15
NOTE:
10.
Connect external cables to the installed card, if needed. Connect internal cables to the system
board, if needed.
48
Chapter 7 Removal and Replacement Procedures Microtower (MT) Chassis
After removing an expansion card, you must replace it with a new card or expansion
Installing an Expansion Card
When installing an expansion card, press firmly on the card so that the whole connector
Securing the Expansion Cards and Slot Covers
The appearance of the power supply varies based on model.
Advertisement
Table of Contents
