Sony MEX-100NV Installation Manual page 43

Einbauanl_CD5_0.book Seite 41 Montag, 1. Juli 2002 2:38 14
Changing the calibration (
Deleting the calibration:
If the navigation system is removed from one vehicle and installed in
another, it must be calibrated. However, to do so, the current calibration
data must be deleted.
In the Service Mode, select
and press to confirm.
Using the SELECT control select
calibration is deleted and the unit returns to the Service Mode.
Calibration setting:
Calibration settings should only be made when the val-
ues to be entered are known. The unit cannot perform
correct route calculations if incorrect values are en-
tered.
It is possible to provide calibration settings.
In the Service Mode, select
and press to confirm.
Using theSELECT control select
Unit rotation can be selected in degrees by turning the SELECT control
and pressing to confirm.
Subject to correction and technical modifications
)
using the SELECT control
and press to confirm. The
using the SELECT control
and press to confirm.
41
Installation guide
C A L I B R A T I O N
D E L E T E
C A L I B R A T I O N
M O D I F Y
0
Copyright by Becker GmbH, D-76303 Karlsbad