Installing And Commissioning Mex-100Nv; Using Gps For The First Time, And Sensors - Sony MEX-100NV Installation Manual

Einbauanl_CD5_0.book Seite 34 Montag, 1. Juli 2002 2:38 14
Installation guide

7. Installing and commissioning MEX-100NV

• This navigation system has an integrated universal bracket for DIN installation slots. An installation frame is not
required. The unit is inserted into the installation slot and secured with the slides supplied.
Further information is given in the operation guide in the chapter, "Installation and removal instructions".
The installation angle of the unit must not exceed -10° to 35° (vertical).
• Connect the battery.

8. Using GPS for the first time, and sensors

• Switch on the vehicle ignition to start using GPS for the first time
and for the sensor test. Switch on MEX-100NV.
Enter code (see the operation guide for a detailed description).
• Press the multifunction button and the
button simultaneously.
• This calls up the menu for the initial GPS start-up and for the sen-
sor test.
• Move the vehicle several metres forwards or backwards for the
speed signal function test.
The number under
speed).
The number under
or pressing the accelerator when the vehicle is parked.
Subject to correction and technical modifications
multifunction
must change (even at a low
should not increase when idling
34
S W R 4 K A
101.6
Speed Direction
0 0 0
Speed Direction
0 1 2
Copyright by Becker GmbH, D-76303 Karlsbad