Replacing The Cutter - Epson SureColor SC-T3000 User Manual

SC-T7000 Series/SC-T5000 Series/SC-T3000 Series User's Guide
C
Place the used Maintenance Box in the clear bag
included with your new Maintenance Box, and
make sure that the zipper is closed tight.
D
Install the new Maintenance Box.
c
Important:
Do not touch the IC chip on the side of
Maintenance Box.
Doing so may prevent normal operation and
printing.
E
Close the maintenance box cover.

Replacing the Cutter

Replace the cutter when it is not cutting paper cleanly.
Supported cutter
"Options and Consumable Products" on
U
page 137
Use a cross-head screwdriver to replace the cutter. Make
sure you have a cross-head screwdriver with you before
replacing the cutter.
Maintenance
c
Important:
Take care not to damage the cutter blade. Dropping
it or knocking it against hard objects may chip the
blade.
Buttons that are used in the following settings
A
Remove any paper from the printer.
"Removing the roll paper" on page 28
U
"Removing Cut Sheets" on page 31
U
"Removing Poster Board" on page 34
U
B
Confirm that the printer is ready to print. Press
the l/r buttons to highlight - and press the Z
button.
The Maintenance menu will be displayed.
C
Press the d/u buttons to highlight Cutter
Maintenance and press the Z button.
D
Press the d/u buttons to highlight Replace
Cutter and press the Z button.
E
The cutter will move to the replacement position.
F
Remove the old cutter from the printer.
Loosen the screw holding the cutter in place
using a cross-head screwdriver and pull the
cutter straight out.
121