Removing Cut Sheets; Loading And Removing Poster Board; Loading Poster Board - Epson SureColor SC-T3000 User Manual

SC-T7000 Series/SC-T5000 Series/SC-T3000 Series User's Guide

Removing Cut Sheets

This section describes how to remove cut sheets when
printing is complete.
Note:
To remove paper that was loaded but not used, press the
( button and select Remove Paper.
Buttons that are used in the following settings
A
Confirm that Paper Eject is displayed in the
control panel.
Keeping a hand on the cut sheets to prevent them
falling from the printer, press the Z button.
B
The paper will be fully ejected from the printer
and can then be removed by hand.
Basic Operations
Loading and Removing
Poster Board
This section describes how to load and remove poster
board from 0.9 to 2.1 mm thick.
The printer can be used with board of the following
sizes.
A2/A1/B2/B1
*
inch
* Not supported by the SC-T3000 Series.

Loading Poster Board

Poster board requires space both behind and in front of
the printer. The approximate amount of space required
is shown below. If the printer is set up near a wall, make
sure there is enough space at the rear.
Paper Size
A2
A1
B2
B1
24 × 30 inch
30 × 40 inch
c
Important:
Insert the paper just before printing. The roller may
leave an impression on paper that is left in the
printer.
31
* *
/B1 landscape /24 × 30 inch/30 × 40
Front (a) Back (b)
444 mm
691 mm
578 mm
880 mm
612 mm
866 mm
135 mm
382 mm
269 mm
571 mm
303 mm
557 mm