Wiring With No Telco Line - Chamberlain Elite EL2000 Installation Manual

Wiring with No Telco Line

The unit can be a stand alone system that allows communication between the unit and a resident's phones.
Never run Telco wires and High
Voltage wires in the same
conduit. The high voltage wires
may interfere with the Telco
wires, possibly causing the
system to malfunction.
NOTE: Ringer Equivalence Number (REN) of "5" maximum.
IMPORTANT: You must program the unit ID's for each
unit wired in the series. See Keypad Programming Manual.
IMPORTANT: Only disable the Telco mode of the unit farthest
away from the house. See "Disable Telco Mode" in the
Keypad Programming Guide.
Single Unit
NOTE: Ringer Equivalence Number (REN) of "5" maximum.
Use 18-24 AWG
2 twisted pair
Multiple Units (Up to 7)
Home Phone
Use 18-24 AWG
2 twisted pair
To next unit (Unit ID 3 then 4 etc.)
Page 11
Output Board
(See page 6)
RES
Ring
Tip
TELCO
Ring
Tip
RES
Ring
Tip
Unit ID 1
Output Board
(See page 6)
TELCO
Ring
Tip
RES
Ring
Tip
Unit ID 2
Output Board
(See page 6)
TELCO
Ring
Tip