El25 Installation; Rotating The Keypad For Vertical Mounting - Chamberlain Elite EL2000 Installation Manual

Caution! A Static Discharge can Damage Circuit Boards
Unlock Unit
1
Line up Notch with
4
Screw and Push
Hinge Out
Screw
DO NOT pinch wires when
closing and locking the unit.

Rotating the Keypad for Vertical Mounting

Caution! A Static Discharge can
Damage Circuit Boards
Disconnect all Plugs from Main Circuit Board and
1
Remove Board. (4 Screws)
Remove Bracket. (4 Screws)
2
Rotate Keypad 90 Degrees Clockwise.
3
Reverse the Sequence to Reassemble Unit.
4
ONLY Vertical
Mounting Position

EL25 Installation

NOTE: This unit is for surface mount applications only.
Carefully Lift Cover Up
2
then Slide Out on Hinges
Notch
2
1
Main Circuit
Board
3
Remove Back Mounting Plate from Cover
5
DO NOT overload the removable
terminal block connectors.
One wire per hole.
For EL25 ONLY
3 Keypad
Bracket
NOTE: Bracket notch lines up
with ribbon cable on keypad.
Main Circuit Board Connections
J200 - Speaker J401 - Keypad
J402 - Light J406 - Light
J404 - Call Button Board J201 - Microphone
Page 3
Unplug the 2 Main Harnesses