IBM HS12 - BladeCenter - 8028 Service Manual page 104

v Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved.
v See Chapter 4, "Parts listing, Types 8014, 8028 and 1916," on page 25 to determine which components are CRUs
and which components are FRUs.
v If an action step is preceded by "(Trained service technician only)," that step must be performed only by a
trained service technician.
Error code Description
1762 Hard disk drive configuration has changed. 1. Run the Configuration/Setup Utility program,
92
BladeCenter HS12 Type 8014, 8028 or 1916: Problem Determination and Service Guide
Action
make sure that the hard disk drive configuration
is correct, and save the settings. See "Using the
Configuration/Setup Utility program" on page
15.
2. Reseat the storage drives. Depending on your
storage drive configuration, use the following
information to reseat your storage drives:
v Fixed-storage drive - See "Removing a
fixed-storage drive" on page 41 and "Installing
a fixed-storage drive" on page 42.
v Hot-swap storage drive - See "Removing a
hot-swap storage drive" on page 43 and
"Installing a hot-swap storage drive" on page
44.
3. If an optional expansion unit is installed, reseat it
- See "Removing an optional expansion unit" on
page 37 and "Installing an optional expansion
unit" on page 38.
4. Replace the following components one at a time,
in the order shown, restarting the blade server
each time:
a. Storage drives:
v Fixed-storage drive - See "Removing a
fixed-storage drive" on page 41 and
"Installing a fixed-storage drive" on page
42.
v Hot-swap storage drive - See "Removing a
hot-swap storage drive" on page 43 and
"Installing a hot-swap storage drive" on
page 44.
b. Optional expansion unit (if one is installed) -
See "Removing an optional expansion unit"
on page 37 and "Installing an optional
expansion unit" on page 38.
c. (Trained service technician only) System-board
assembly - See "Removing the system-board
assembly" on page 65 and "Installing the
system-board assembly" on page 66.