IBM 9228 - IntelliStation Z - Pro User Manual page 66

10. Touch the static-protective package containing the new microprocessor to any
11. Make sure that the microprocessor socket lever and cover are in the fully open
12. Install the microprocessor:
13. Close the microprocessor bracket frame; then, close the microprocessor
54
IBM IntelliStation Z Pro Type 9228: User's Guide
9. If the second microprocessor socket is covered with protective film or a label,
peel and remove the film or label.
unpainted metal surface on the computer; then, remove the microprocessor
from the package.
position.
Attention: To install the second microprocessor, use the vacuum tool that
comes with the new microprocessor. Dropping the microprocessor during
installation can damage the contacts. Also, contaminants on the
microprocessor contacts, such as oil from your skin, can cause connection
failures between the contacts and the socket.
Vacuum tool
Microprocessor
Socket
a. Squeeze and hold the bladder of the vacuum tool; then, place the suction
cup on the microprocessor and release the bladder.
Note: To maintain the correct orientation between the microprocessor and
the microprocessor socket during installation, observe the following
information:
v The microprocessor has two notches that are keyed to two tabs
on the sides of the socket.
v A triangle-shaped indicator on one corner of the microprocessor
points to a 45-degree angle on one corner of the socket.
b. Using the vacuum tool, carefully place the microprocessor into the socket.
c. Squeeze the bladder of the vacuum tool to release the microprocessor
from the suction cup.
retention latch and lock it securely in place.