Chapter 4. Installing Options; Installation Guidelines; System Reliability Considerations - IBM 9228 - IntelliStation Z - Pro User Manual

Chapter 4. Installing options

This section provides instructions for installing and replacing hardware options in
the computer. For a list of supported options for the computer, go to
http://www.ibm.com/intellistation/; then, select your country and navigate to the list
of options for the computer.

Installation guidelines

Before you install options, read the following information:
v Read the safety information that begins on page v and the guidelines in
v When you install your new computer, take the opportunity to download and apply
v Observe good housekeeping rules in the area where you are working. Place
v Do not attempt to lift an object that you think is too heavy for you. If you have to
v Make sure that you have an adequate number of properly grounded electrical
v Back up all important data before you make changes to disk drives.
v Have a small flat-blade screwdriver available.
v When you have to access the inside of the computer to install options, you might
v Blue on a component indicates touch points, where you can grip the component
v When you are finished working on the computer, reinstall all safety shields,

System reliability considerations

To help ensure proper system cooling and system reliability, make sure that the
following requirements are met:
v Each of the drive bays has a drive or a filler panel and electromagnetic
v There is adequate space around the computer to allow the computer cooling
© Copyright IBM Corp. 2006
"Handling static-sensitive devices" on page 30. This information will help you
work safely.
the most recent firmware updates. This step will help to ensure that any known
issues are addressed and that your computer is ready to function at maximum
levels of performance. To download firmware updates for your computer, go to
http://www.ibm.com/support/ and click Downloads and drivers.
removed covers and other parts in a safe place.
lift a heavy object, observe the following precautions:
– Make sure that you can stand safely without slipping
– Distribute the weight of the object equally between your feet.
– Use a slow lifting force. Never move suddenly or twist when you lift a heavy
object.
– To avoid straining the muscles in your back, lift by standing or pushing up with
your leg muscles.
outlets for the computer, monitor, and other devices.
find it easier to lay the computer on its side.
to remove it from or install it in the computer, open or close a latch, and so on.
guards, labels, and ground wires.
compatibility (EMC) shield installed in it.
system to work properly. Leave approximately 50 mm (2 in.) of open space
around the front and rear of the computer. Do not place objects in front of the
fans. For proper cooling and airflow, replace the computer cover before turning
29