IBM 9228 - IntelliStation Z - Pro User Manual page 23

What you see and hear when you start the computer depends on the features that
are installed and the settings in the Configuration/Setup Utility program.
If power-on self-test (POST) detects a problem, there might be a series of beeps or
no beep, and a numeric error message might appear on the screen. Write down
any beep series and error code numbers with descriptions, and then see the
Problem Determination and Service Guide for an explanation of the error codes.
On a computer running a Windows operating system, the following messages might
be displayed briefly during startup:
v Press F1 for Configuration/Setup Utility, Press F12 for Boot Menu
v <<< Press <CTRL><C> to start LSI Logic Configuration Utility >>> (some
models)
v To start the Product Recovery Program, Press F11
On a computer running a Red Hat Linux operating system, the following messages
might be displayed briefly during startup:
v Press F1 for Configuration/Setup Utility, Press F12 for Boot Menu
v <<< Press <CTRL><C> to start LSI Logic Configuration Utility >>> (some
models)
To start the Product Recovery Program in Red Hat Linux, watch the screen until the
operating system selection menu is displayed and select IBM Preload Recovery &
Diagnostics.
To use these features, press the applicable function key or keys quickly. The
messages appear for only a short time. For more information about these
messages, see "Using the Configuration/Setup Utility program" on page 21.
Use the Configuration/Setup Utility program to configure passwords, PCI adapters,
and other options.
The operating system and application programs start from the hard disk. If the
computer is attached to a network, the computer will begin attaching to any LANs
and remote applications to which you have access. A network administrator can
also start the computer remotely to download programs or gather information about
computer performance. For more information, see "Wake on LAN" on page 18.
Chapter 2. Operating the computer
11