IBM 9228 - IntelliStation Z - Pro User Manual page 52

v The computer comes with integrated IEEE 1394A (FireWire) support.
v For a list of supported options for the computer, see http://www.ibm.com/
To install an adapter, complete the following steps:
40
IBM IntelliStation Z Pro Type 9228: User's Guide
– Slot 4, PCI-X, 64-bit, 133 MHz
– Slot 5, PCI-X, 64-bit, 133 MHz
– Slot 6, PCI, 32-bit, 33 MHz
The computer starts the PCI devices in the following order, if you have not
changed the default startup sequence: PCI Express x16 (slot 1), PCI Express x8
(slot 2), PCI Express x16 (slot 3), system-board IDE or Serial ATA (SATA)
devices, PCI-X slots 4 and 5, and then PCI slot 6.
intellistation/; then, select your country and navigate to the list of options for the
computer.
1. Read the safety information that begins on page v and "Installation guidelines"
on page 29.
2. Turn off the computer and all attached devices (see "Turning off the computer"
on page 18); then, disconnect all external cables and power cords.
3. Remove the side cover (see "Removing the side cover" on page 35).
4. Determine which PCI slot you will use for the adapter. Check the instructions
that come with the adapter for any requirements, restrictions, or cabling
instructions. It might be easier to route cables before you install the adapter.
5. If an adapter is already installed in the slot, remove it, using the following
procedure, and place it on a static-protective surface:
Note: For full-length adapters, rotate the rear adapter-retention bracket to the
open (unlocked) position. Press the two blue release buttons located on
the side of the front adapter-retention bracket that faces the adapters. If
you are installing a smaller adapter, rotate only the rear
adapter-retention bracket. Grasp the adapter and pull it out of the slot.
If the slot is empty, remove the expansion-slot cover. From the rear of the
computer, press on the slot cover. Grasp it and pull it out of the expansion slot.
Store it in a safe place for future use.
Attention: Expansion-slot covers must be installed in all empty slots. This
maintains the electronic emissions standards of the computer and ensures
proper ventilation of computer components.
6. Follow the instructions that come with the adapter to set jumpers or switches, if
there are any.
Attention: Avoid touching the components and gold-edge connectors on the
adapter.
7. If you are installing a full-length adapter, remove the blue adapter guide (if any)
from the end of the adapter.