IBM 9228 - IntelliStation Z - Pro User Manual page 57

Statement 3:
CAUTION:
When laser products (such as CD-ROMs, DVD drives, fiber optic devices,
or transmitters) are installed, note the following:
v Do not remove the covers. Removing the covers of the laser product
could result in exposure to hazardous laser radiation. There are no
serviceable parts inside the device.
v Use of controls or adjustments or performance of procedures other
than those specified herein might result in hazardous radiation
exposure.
DANGER
Some laser products contain an embedded Class 3A or Class 3B laser
diode. Note the following.
Laser radiation when open. Do not stare into the beam, do not view
directly with optical instruments, and avoid direct exposure to the
beam.
Class 1 Laser Product
Laser Klasse 1
Laser Klass 1
Luokan 1 Laserlaite
`
Appareil A Laser de Classe 1
7. Touch the static-protective package that contains the drive to any unpainted
metal surface on the computer; then, remove the drive from the package and
place it on a static-protective surface.
8. Set any jumpers or switches on the drive according to the documentation that
comes with the drive.
Note: You might find it easier to install the new drive from the front and then
attach the cables.
9. Install the drive in bay 2 or bay 3.
To install the drive in bay 2, complete the following steps:
a. Remove the drive retainer clip from the side of the drive cage of bays 1, 2,
and 3 (see the illustration at the beginning of this section). Slide the drive
retainer clip to the left to disengage it from the drive cage; then, snap the
drive retainer clip into the screw holes on the side of the drive (the blue
side of the drive retainer clip should be facing outward).
b. If you are installing a 5.25-in. drive in bay 2, push the drive into the drive
bay until it snaps in place. If you are installing a 3.5-in. drive in bay 2,
attach the 5.25-in. conversion kit and push the drive into the drive bay until
it snaps in place.
Chapter 4. Installing options
45