IBM 9228 - IntelliStation Z - Pro User Manual page 58

10. Determine whether the drive is an IDE, SATA, or SAS device; then, connect
11. Route the signal cable so that it does not block the airflow to the rear of the
12. If you have other options to install or remove, do so now.
13. Connect the power cable to the back of the drive. The connectors are keyed
14. Replace the two-piece bezel (see "Replacing the two-piece bezel" on page 57).
15. Replace the side cover (see "Replacing the side cover" on page 59).
Installing a simple-swap hard disk drive in bay 4, 5, 6, or 7
This procedure applies to computer models that have simple-swap hard disk drives.
Simple-swap hard disk drives are easily accessible from the front of the computer.
Four SAS or SATA hard disk drives can be installed in bays 4 through 7. Drives are
installed starting in bay 4. Additional drives are installed in bays 5, 6, and 7. Before
you install a simple-swap hard disk drive, read the following information:
v Read the documentation that comes with the hard disk drive for cabling
v You can install four simple-swap SATA or SAS hard disk drives in the computer.
v You must turn off the computer before removing and replacing simple-swap
v Install simple-swap hard disk drives in this sequence: bay 4, bay 5, bay 6, and
v Bays 4, 5, 6, and 7 are simple-swap bays and do not require cabling.
46
IBM IntelliStation Z Pro Type 9228: User's Guide
c. Continue with step 10.
To install an optional diskette drive in bay 3, complete the following
steps:
a. Remove the small drive clip that is attached to the side of bay 3 of the
drive cage for bays 1, 2, and 3. Slide the drive clip to the left to disengage
it from the drive cage; then, snap the drive clip into the screw holes on the
side of the replacement drive.
b. Slide the drive into the drive bay until it snaps in place.
one end of the applicable signal cable into the back of the drive and make
sure that the other end of this cable is connected into the applicable IDE,
SATA, or SAS connector.
drives or over the microprocessor and DIMMs.
and can be inserted only one way.
instructions.
drives.
bay 7.
To install a simple-swap hard disk drive, complete the following steps.