Table of Contents
Advertisement
Retaining the cables
The RS-232 cable is retained to the system unit with screws. The Ethernet cable is
retained by a snap on the connector. When closed, the cable cover retains the
power cable. SeeFigure 4.
Figure 4. Retaining the cables using cable ties
You can retain the audio cables and USB cables by placing cable ties
outside of the covers. The slots in the cable covers retain the ties. Install the cable
ties as follows:
1. Plug each cable into its respective connector.
2. Install the cable ties to the cable just outside the cable cover as shown in A in
3. Open the cable covers ( B in Figure 4).
4. Place the cables with the cable ties inside of the cable covers.
5. Close and secure the cable covers with the cable ties inside of the covers ( C
Installing the options
The design of the IBM 4836 allows you to install the hard drive, scanner and MSR
without removing the external cover. Many upgrade features are factory-installed.
See Figure 2 on page 8 to identify the access doors.
1. The cable ties are 5 mm (.2 in.) wide.
10
Anyplace Kiosk 4836
All manuals and user guides at all-guides.com
Figure 4.
Note: Ensure that the cable tie is tight and does not move.
in Figure 4).
A
B
C
1
on the
Advertisement
Table of Contents
