Using The Reset Button To Restore Factory Default Settings - NETGEAR WAG302 - ProSafe Dual Band Wireless Access Point Reference Manual

Dual band wireless access point (802.11a/g)

Hide thumbs Also See for WAG302 - ProSafe Dual Band Wireless Access Point:

Table of Contents

ProSafe Dual Band Wireless Access Point WAG302 Reference Manual (802.11a/g)

Using the Reset Button to Restore Factory Default Settings

The Reset button (see

•

Reboot. When pressed and released quickly, the WAG302 will reboot (restart).

•

Reset to Factory Defaults. This button can also be used to clear ALL data and restore ALL

settings to the factory default values.

To clear all data and restore the factory default values:

1. Power off the WAG302 and power it back on.

2. Use something with a small point, such as a pen, to press the Reset button in and hold it in for

at least 5 seconds.

3. Release the Reset button.

The factory default configuration has now been restored, and the WAG302 is ready for use.

5-4

"Rear Panel" on page

v2.0, May 2006

1-8) has two functions:

Troubleshooting

Table of Contents