ProSafe Dual Band Wireless Access Point WAG302 Reference Manual (802.11a/g)
will then configure itself to the correct configuration. This feature also eliminates any concerns
about crossover cables, as Auto Uplink will accommodate either type of cable to make the right
connection.
Compatible and Related NETGEAR Products
For a list of compatible products from other manufacturers, see the Wireless Ethernet
Compatibility Alliance Web site (WECA, see http://www.wi-fi.net).
The following NETGEAR products work with the WAG302 Wireless Access Point:
•
WAG511 ProSafe 108 Mbps Dual Band PC Card
•
WAG311 ProSafe 108 Mbps Dual Band PCI Card
•
WG311T 802.11g 108 Mbps Wireless PCI Card
•
WG511T 802.11g 108 Mbps Wireless CardBus Adapter
•
WG511 802.11g 54 Mbps Wireless CardBus Adapter
•
WG111 801.11g 54 Mbps Wireless USB Adapter
System Requirements
Before installing the WAG302, make sure your system meets these requirements:
•
A 10/100 Mbps Local Area Network device such as a hub or switch
•
The Category 5 UTP straight through Ethernet cable with RJ-45 connector included in the
package, or one like it
•
A 100-240 V, 50-60 HZ AC power source
•
A Web browser for configuration such as Microsoft Internet Explorer 6.0 or above, or
Netscape Navigator 4.78 or above
•
At least one computer with the TCP/IP protocol installed
•
802.11b or 802.11b-compliant devices, such as the NETGEAR WG511 Wireless Adapter
What's In the Box?
The product package should contain the following items:
•
ProSafe 802.11a/g Dual Band Wireless Access Point WAG302
Introduction
v2.0, May 2006
1-5