Manually Configuring The Internet Connection - NETGEAR SRXN3205 - ProSafe Wireless-N VPN Firewall Wireless Router Reference Manual

ProSafe Wireless-N VPN Firewall SRXN3205 Reference Manual
The WAN Status window should show a valid IP address and gateway. If the configuration
was not successful, skip ahead to
this section, or see
Note: If the configuration process was successful, you are connected to the Internet
through the WAN port.
4. If your WAN ISP configuration was successful, you can test the internet connection, or skip
ahead to..........
5. Click Test to evaluate your entries.
The firewall will attempt to connect to the NETGEAR Web site. If a successful connection is
made, NETGEAR's Web site appears.
If the automatic WAN ISP configurations failed, you can attempt a manual configuration as
described in the following section, or see

Manually Configuring the Internet Connection

Unless your ISP automatically assigns your configuration automatically via DHCP, you will need
to obtain configuration parameters from your ISP in order to manually establish an Internet
connection. The necessary parameters for various connection types are listed in
To manually configure your WAN ISP Settings:
1. Select Network Configuration> WAN ISP Settings and enter the following:
2. In the ISP Login options, choose one of these options:
• If your ISP requires an initial login to establish an Internet connection, click Yes (this is
the default).
• If a login is not required, click No and ignore the Login and Password fields.
Figure 2-6
3. If you clicked Yes, enter the ISP-provided Login and Password information.
2-6
"Manually Configuring the Internet Connection"
"Troubleshooting the ISP Connection" on page
"Troubleshooting the ISP Connection" on page
v1.0, October 2008
12-4.
Table 2-1.
Connecting to the Internet (WAN)
following
12-4.