Attaching The Tripod Base (Provided Only For U Model) - JVC GY-HD250U - 3-ccd Prohd Camcorder Instructions Manual

e_hd250.book Page 35 Tuesday, October 24, 2006 3:11 PM
Attaching the Tripod Base
(Provided only for U model)
Use the provided tripod base to place the camera on a tri-
pod. (U model only)
1.
Attach the tripod base on the tripod by using the hole that
balances this device most optimally.
1.
Tripod mounting holes
2.
While pushing the safety lever, pull the lock lever toward
the front until the front mount clip clicks into place.
Front mount clip
2.
Safety lever
3.
Place this device on the tripod base by aligning the rear
base mount of this device with the pin on the tripod base.
4.
Front base mount
4.
Hold the camera on the top and slide forward so that the
base mount of the camera is locked by the front mount
clip of this device as it clicks into place.
USER 1
ND FILTER
2
1
WHT.BAL
ON
POWER
3.
Pin
2.
Lock lever
3.
Rear base mount
4.
VF BRIGHT
USER 2 USER 3
MENU
STATUS
AUTO AUTO
AUDIO
LEVEL
CH-1 CH-2
OFF
REC
CAUTION
• The front base mount may be locked while the pin of the
tripod base is not inserted into the hole on the rear base
mount of this device. Therefore, after mounting, make
sure that these parts are engaged properly.
• When moving this device mounted on a tripod, any
impact or vibration should be avoided as this may cause
this device to become detached and to drop from the tri-
pod.
Be sure to remove this device from the tripod before
transporting it.
35