JVC GY-HD250U - 3-ccd Prohd Camcorder Instructions Manual page 112

e_hd250.book Page 108 Tuesday, October 24, 2006 3:11 PM
OTHERS
Warnings and Responses (Cont'd)
Error code
• Warning Indications for VTR Abnormalities
Should malfunctions occur during VTR operation, this
device self-diagnoses the cause and shows the diagnose
together with an error code on the LCD monitor or in the
viewfinder.
Error Code
0201
CONDENSATION ON DRUM
3200
LOADING FAILURE
3300
UNLOADING FAILURE
4100
CASSETTE EJECT FAILURE
5605 - 5609
DEFECTIVE TAPE
5702
TAPE END DET. ERROR
5802
TAPE BEGIN DET. ERROR
7001
DRUM MOTOR FAILURE
7101
CAP MOTOR FAILURE
7202 - 7203
SUPPLY REEL FAILURE
7302 - 7303
TAKE UP REEL FAILURE
7305
TAKE UP REEL FAILURE
8000
EMERGENCY TAPE!
TURN POWER OFF.
TURN BACK ON LATER.
108
Warning
Error Details
Indicates dew formation (condensa-
tion).
Tape cannot be loaded.
Tape cannot be unloaded.
Irregularity with eject operation.
Tape is cut.
Tape end sensor error.
Tape beginning sensor error.
Drum rotation error.
Capstan rotation error.
Supply reel rotation error.
Take up reel rotation error.
Take up reel rotation error when un-
loading.
Tape problem detected.
System error when power is turned on. HDV/DV LED, VTR indicator
GY-HD250/GY-HD251
Operation
Operation stops. All opera- Leave this device with the power ON,
tions are rejected. until the indication disappears.
X See page 9.
Switch the power OFF and then switch
it back ON. However, the tape may be
damaged depending on the circum-
stances. Please consult the person in
charge of professional video equip-
ment at your nearest JVC-authorized
service agent.
Operation stops. Press the EJECT button to take out the
cassette.
If the tape runs out during recording,
switch the power OFF and then switch
it back ON, press the EJECT button,
and then take out the cassette.
Operation stops. All opera- Switch the power OFF and then switch
tions are rejected. it back ON. However, the tape may be
damaged depending on the circum-
stances. Please consult the person in
charge of professional video equip-
ment at your nearest JVC-authorized
service agent.
Turn off the power and let this device
and TALLY lamp flash. Only sit for sometime before turning it back
POWER switch operation is on.
accepted.
Remedy