Xerox 850DP - Phaser Color Solid Ink Printer Manual page 91

Version 10.0
AccXES PJL Interface
This variable is used to specify the X (Y) position of the label as either an absolute coordinate, or
through a relative positioning value. Using absolute coordinates, this parameter specifies the X (Y)
coordinate of the label's bounding box's lower left corner in inches from the physical paper's origin. In
relative coordinates, the value LEFT (BOTTOM), CENTER, OR RIGHT (TOP) may be used. In these
cases, the rotated label is justified within the page's plotting area on the left, center, or right side.
See the PAGEROTATE section, which describes the PAGEROTATE variable for the location of the
physical paper's origin for both cut sheet and roll paper sizes. This origin is not affected by margin or
justification settings.
There are three special values for LABELLOCX: LEADING, TRAILING, and EXTEND. When
LABELLOCX is LEADING or TRAILING, the coordinate axis of the physical page is forced to be that of
a roll paper size whether the paper is actually a cut sheet or (already) a roll paper size. This exception
allows the user to specify that a label be applied to the leading or trailing of a cut sheet page,
regardless of whether the print is made short edge or long edge. This (possible) change in coordinate
system forced by the value of LABELLOCX affects only label related parameters. When LABELLOCX
is EXTEND the user specifies the number of inches to extend the output page in LABELLOCY.
The default values for these variables are LABELLOCX = LEADING and LABELLOCY = BOTTOM.
NOTE: While not specifically prevented by AccXES, it is highly recommended that the folder
not be used with the EXTEND option.
5.1.7.2.9 LABELROTATE
This variable specifies the rotation of the label relative to the physical page. Possible values are 0
through 359. The default value is 90. See the PAGEROTATE section, which describes the
PAGEROTATE variable for the definition of the coordinate axis of cut sheets and roll paper sizes.
Rotation is specified counter-clockwise from the X axis.
Note that when LABELLOCX is LEADING, TRAILING, or EXTEND, the coordinate axis of the
physical page is forced to be that of a roll paper size whether the paper is actually a cut sheet or
(already) a roll paper size. This exception allows the user to specify that a label be applied to the
leading, trailing, or extended edge of a cut sheet page, regardless of whether the print is made short
edge or long edge. This (possible) change in coordinate system forced by the value of LABELLOCX
affects only label related parameters.
5.1.7.2.10 LABELSHADING
This parameter specifies the label's shading level as a percentage of colorant applied to mark the label.
100% corresponds to pure black and 0% corresponds to blank (white). With 0%, no marks are made on
the paper. The label will be rendered with a transparent rendering merge control such that at 50%, for
example, the underlying image may be seen "bleeding" through the label. The default value is 100.
5.1.7.2.11 LABELSIZE
This parameter specifies the size of the font used in points. The default value for this parameter is 18
point.
5.1.7.2.12 LABELSTRING
Page 86 of 160