Xesmediadef; Xesmediadictionary - Xerox 850DP - Phaser Color Solid Ink Printer Manual

<media mismatch mode> is one of the following enumerated values: {BLOCK, SUBSTITUTE, SCALE}.
Note that this new command supercedes the old MM_MODE_<media> commands beginning with
AccXES V7.5. This is an optional field.
<color gamma value> is a float from 0.5 to 2.0 that defines the gamma value for the color curve that is
used during the printing process. This is an optional field.
<color ink limit value> is an integer from 0% to 100% that defines the ink limit for the color curve that
is used during the printing process. This is an optional field.

4.1.11 XESMEDIADEF

Similar to XESMEDIASET, this command is used to set job and/or page parameters that are media
dependent. However, this command is used to change the printer default values rather than only the
current job's values.
Similar to XESMEDIASET, the syntax of the command is:
@PJL COMMENT XESMEDIADEF NAME=<media name>
MISMATCHMODE=<media mismatch mode>
GAMMACYAN=<cyan gamma value>
GAMMAMAGENTA=<magenta gamma value>
GAMMAYELLOW=<yellow gamma value>
GAMM BLACK=<black gamma value>
INKLIMITCYAN=<cyan ink limit value>
INKLIMITMAGENTA=<magenta ink limit value>
INKLIMITYELLOW=<yellow ink limit value>
INKLIMITBLACK=<black ink limit value>
<FF>
The arguments are the same as for the XESMEDIASET command.

4.1.12 XESMEDIADICTIONARY

This command will report the contents of the AccXES media dictionary including the fold program and
titleblock locations for the defined sizes.
Unsupported media sizes will not be displayed via this PJL instruction.
After parsing the XESMEDIADICTIONARY command, the controller will echo the command, the
appropriate status, and a form-feed back on the sending channel as shown below:
@PJL COMMENT XESMEDIADICTIONARY
<media size><status> WID: <width> HT: <height>
Prg: <fold program> <foldable flag> <foldeable range1> : <titleblock locations> <alternat
titleblock>
where:
media size: corresponds to one of the possible specifications for PAPER.
Status: Enabled/Disabled - Disabled means no printer.
Width: Pixel count of nubmer fo scan lines AccXES sends.
Height: Number of pixels in the height of a particular sheet size.
Fold Program: Program number of fold
Foldable flag: T for TRUE - foldable; F for FALSE - not foldable
Foldable Range:mm range ("841-3300" representing min and max number of mm for a given fold.
Version 10.0
AccXES PJL Interface
Page 17 of 160