Xesfinisher - Xerox 850DP - Phaser Color Solid Ink Printer Manual

CGM=<Feature Status>
SCAN_TO_PRINT=<Feature Status>
IOT_7D=<Feature Status>
IOT_10D=<Feature Status>
IOT_2DRAWER=<Feature Status>
IOT_3DRAWER=<Feature Status>
<FF>
The Feature Status contains the status of the feature: ENABLED, or DISABLED. An exception is
SCANNER_SPEED_ENHANCEMENT which contains NORMAL, TURBO_II, TURBO_III, or
DISABLED. The value DISABLED is displayed when the connected scanner device does not support
the speed enhancement feature (ex. Vidar) or if there is no scanner attached at all. In order to be
enabled a software license for the feature must be present (if required) and the minimum hardware
configuration to support the feature must be present.

6.19 XESFINISHER

This category is a custom AccXES extension to report the capabilities of the currently attached finisher.
The defined response is:
@PJL INFO XESFINISHER
MODEL = < GFI Model Number (string)>
VERSION = < GFI Interface Level (string) >
NUMPROGRAMS = < Number of GFI Finishing Programs (integer) >
NUMBINS = < Number of bins (integer) >
FANFOLDS = < This list is a superset of all possible values >
OTHER
NONE
FULL_FRONT_END_LEFT
FULL_BACK_END_LEFT
FULL_FRONT_AND_BACK_END_LEFT
TOP_PANEL_BINDING
MIN_COMP_HALF_BACK
MIN_COMP_INTERNAL
MIN_COMP_ENDLESS
Version 10.0
AccXES PJL Interface
Page 119 of 160