Before Configuring The Device (Required); Verifying Physical Interfaces And Installed Firmware; Attaching A Lock - Lexmark Color Laser Installation And Administration Manual

•
Authorized administrators are knowledgeable about, and capable of performing tasks related to the installation,
configuration, and maintenance of the network environment including—but not limited to—operating systems,
network protocols, and security policies and procedures.

Before configuring the device (required)

Before beginning configuration tasks, you must:
•
Verify that no optional interfaces are installed
•
Verify the firmware
•
Attach a lock to the MFP
•
Encrypt the hard disk (if installed)

Verifying physical interfaces and installed firmware

1
Inspect the MFP to verify that only one network interface is installed. There should be no optional network, parallel,
or serial interfaces.
Note: USB ports that perform document processing functions are disabled at the factory.
2
Turn the MFP on using the power switch.
3
From the home screen touch Menus > Reports > Menu Settings Page. Several pages of device information will
print.
4
Under Installed Features, verify that no Download Emulator (DLE) option cards have been installed.
5
If you find additional interfaces, or if a DLE card has been installed, contact your Lexmark representative before
proceeding.
6
To verify the firmware version, under Device Information, locate Base =, and Network =.
7
Contact your Lexmark representative to verify that the Base and Network values are correct and up-to-date.

Attaching a lock

Once a lock is attached, the metal plate and system board cannot be removed, and the security jumper cannot be
accessed without causing visible damage to the device.
1
Verify that the MFP case is closed.
2
Locate the security lock port and attach a lock. It is the same type of lock port found on most laptop computers,
and can normally be found on the back of the MFP, near an outside edge.
6