Konica Minolta bizhub PRO 1051 User Manual page 326

Utility Tool
Note
The network interface card will also operate with other host-resident print
supervisor/spooler programs that present a print image to the image con-
troller over a TCP/IP port.
Printing overview
Considering both the host-based and printer-based TCP/IP printing capabil-
ities, the network interface card works with the following systems:
- All UNIX systems that support lpd
- System V Rel. 4 (on 386 platforms)
- Solaris:
– Version 1.1.3 (SunOS 4.1.3),
– Version 2.3 (SunOS 5.3),
– Version 2.4, and
– Version 2
- HP-UX Series 700 and 800 Version 9.01 and Version 10
- IBM AIX Version 3.2.5 and Version 4.0
- SCO UNIX Version 3.2
- AS400
Note
If the systems you are using do not run lpd, refer to "Installing UNIX TCP/
IP programs".
The UNIX-TCP/IP Programs on accompanying CD-ROM also include
source code so that you can recompose host-based code for configuring
on other System V platforms.
Configuring IP address to the network interface card
Regardless of the printing mode selected, the network interface card must
be given the IP address and routing parameters. You can configure the IP ad-
dress for the network interface card in one of the following ways:
- Use DHCP (Dynamic Host Configuration Protocol).
- Use arp and ping capability.
- Use BOOTP (Internet Boot Protocol).
- Use reverse ARP (rarp) capability (Ethernet II frame type only).
- Use arp command, MAP (Management Access Program), or BOOTP Lite
for Windows.
bizhub PRO 1200/1200P/1051 Printer
13
13-26