NETGEAR WNDR3400 - N600 Wireless Dual Band Router User Manual page 75

Table 5-1. LAN Setup
Settings
LAN TCP/IP IP Address
Setup
IP Subnet Mask
RIP Direction
RIP Version
DHCP Server Use Router as a DHCP
For more Server
information
Starting IP Address
Ending IP Address
Address Reservation
For more information, see
Reservation" on page 5-4.
Customizing Your Network Settings
N600 Wireless Dual Band Router WNDR3400 User Manual
Description
The LAN IP address of the wireless router.
The LAN subnet mask of the wireless router. Combined
with the IP address, the IP Subnet Mask allows a device to
know which other addresses are local to it, and which must
be reached through a gateway or wireless router.
RIP (Router Information Protocol) allows a wireless router
to exchange routing information with other routers. This
setting controls how the wireless router sends and receives
RIP packets. Both is the default.
• Both or Out Only. The wireless router broadcasts its
routing table periodically.
• Both or In Only. The wireless router incorporates the RIP
information that it receives.
This controls the format and the broadcasting method of the
RIP packets that the wireless router sends. It recognizes
both formats when receiving. By default, the RIP function is
disabled.
• RIP-1 is universally supported. It is adequate for most
networks, unless you have an unusual network setup.
• RIP-2 carries more information. Both RIP-2B and RIP-2M
send the routing data in RIP-2 format. RIP-2B uses
subnet broadcasting. RIP-2M uses multicasting.
This check box is usually selected so that the wireless
router functions as a Dynamic Host Configuration Protocol
(DHCP) server. See
on page
Specify the start of the range for the pool of IP addresses in
the same subnet as the wireless router.
Specify the end of the range for the pool of IP addresses in
the same subnet as the wireless router.
When you specify a reserved IP address for a computer on
"Address the LAN, that computer receives the same IP address each
time it access the router's DHCP server. Assign reserved IP
addresses to servers that require permanent IP settings.
v1.0, August 2010
"Using the Router as a DHCP Server"
5-4.
5-3