To Edit The Retrieved One-Touch / Abbr. No. Data - Panasonic DX 1000 - PanaFax B/W Laser Printer User Manual

Programming Auto Dialer Remotely via Email
03005000002

To Edit the Retrieved One-Touch / ABBR. No. Data

Before changing, adding or overwriting, the entire auto dialer has to be erased with a "Delete" command and
03005020003
then restored with the retrieved data that has been updated.
After receiving the DX-1000 email with the auto dialer data, store the email file as text (.txt) on your PC for
backup purposes.
To change or update the auto dialer, follow the steps below:
1) Create a New Email Message, fill out the "To" and "From" Address line and the Subject line information
for section 1) below:
To : The DX-1000's email address.
From : Your email address, for retrieving One-Touch / ABBR. No. data and error message notification
Subject : To Store data: #set abbr(password)#
2) Open the backup, auto dialer text file. Copy the body text and paste it on the body of the newly created
email message.
3) Delete any headers that may be present in the body of the email, as unsupported data will be rejected.
The information following the "#" sign is ignored by the DX-1000.
4) Insert the "@command", "delete" and "@end" commands in section 3) of the email body.
5) Edit and/or add additional One–Touch / ABBR No. stations.
6) When finished, use the "File/Save as.." command and save the updated file with ".txt" extension as
a backup.
7) Send the email message to the DX–1000 to update the auto dialer.
DX-1000 Auto Dialer Email Sample
03005050009
58
1)
6)
[Delete this header before sending email]
2)
3)
4)
5)
1) To : The DX-1000's email address.
From : Your email address, for retrieving
One-Touch / ABBR. No. data and error
messages notification
(It may be programmed with the
configuration tool of your email
program.)
Subject:To Store data: #set abbr(password)
#/ To Retrieve data: #get
abbr(password)#
2) @list to @end block:
Defines the data to be set into One-Touch /
ABBR. No. in section 4) between @begin to
@end block.
station-name: name of the station being
programmed
station-address:email address or telephone
number of the station being
programmed
routing-subaddress: sub-address to be used for
routing
outing-id-number: TSI to be used for routing
3) These command lines, delete the existing
programmed data before reprogramming with
new data between @begin to @end in section
.
4)
4) @begin to @end block: Defines the data to be
programmed between @begin to @end block,
described in 2) above.
5) These 2 One-Touch stations were added to the
list.
6) This header must be deleted before the email is
sent to the DX-1000 for reprogramming of
One-Touch / ABBR. No.