Troubleshooting; If You Have Any Of These Problems - Panasonic DX 1000 - PanaFax B/W Laser Printer User Manual

08001000001

If You Have Any of These Problems

08001020001
Mode
08001080001
During Installation
#@multitude
08001080002
During Transmission
08001080003
Transmission Copy T i i
Quality
08001080004
During Reception g p
08001080091
Symptom
The display is blinking
Document doesn't
feed/multiple feed
Document jam
Does not stamp
Stamp too light
Vertical lines on the
transmitted document
C
Transmitted document
is blank
No recording paper
Recording paper jam
Recording paper
doesn't advance into
machine
Recording paper
doesn't eject after
printing
Recording papers are
not stacked in
sequence. Machine
does not print from the
last page received.
Document auto
reduction doesn't work
Out of toner
Action
Battery is completely discharged. This may happen at first
installation. After setting the clock, the blinking will stop.
1. Check that your document is free of staples and paper
clips, and that it is not greasy or torn.
2. Check that your document is the right type to send through
a fax machine by consulting the list on "Documents You
Cannot Send". If your document has the characteristics
listed, make a photocopy of your document and send the
copy instead.
3. Check that the document is loaded properly.
4. Adjust the ADF Pressure.
The information code 031 will appear on the display if the
document becomes jammed.
1. Check if Stamp LED is lit.
2. Check Fax parameter No. 04 and No. 28 settings.
Replace stamp or refill ink.
Check own copy quality. If copy is OK, your machine has no
problem, report to the receiving party that they have a problem.
If copy is NG, clean the Document Scanning Area.
1. Make sure the document is set face down.
2. Check own copy quality. If copy is OK, your machine has no
problem, report to the receiving party that they have a
problem. If copy is NG, clean the Document Scanning Area.
The information code 010 will appear on the display if the paper
runs out.
The information code 001, 002 or 003 will appear on the display
if the paper gets jammed.
Make sure that there is paper in the Paper Cassette. Follow
the instructions for loading paper.
Check to see if the recording paper is jammed inside of the
machine.
1. Check if Fax Parameter No. 65 is set to valid.
2. If memory becomes full during reception, the machine will
start to print from the 1st page received.
Check Print Reduction settings.
The information code 041 will appear on the display if the Toner
Cartridge runs out of toner.

Troubleshooting

Page
36
65
66
171
168
8
68
60,61
172
169
169
30
167
30
167
62
101
28
161