Configuring The Printer; Basic Settings For The Remote Operation Panel - Oce 1010N - B/W Laser Printer Operation Manual

1.3

Configuring the Printer

1.3.1

Basic Settings for the Remote Operation Panel

This section explains how to set and confirm the printer's configuration
from the Remote Operation Panel utility. The value set from the Remote
Operation Panel utility becomes the printer's default setting. However,
when printing, the printer may automatically switch to another setting,
depending on the application software or printer driver settings.
Before operating the Remote Operation Panel, you can change settings for
polling, error notification, and whether you want to use the 3D virtual
printer to monitor the printer status.
1
Click the SETUP button on the start-up screen.
2
The KM-NET Remote Operation Panel dialog appears. Read the
following explanations, then make the appropriate settings.
Status Polling
1-12
Configuring the Printer
Enable Traps
Browse NIC Web Page button
Polling